When purchasing an LED display, there are many items that need to be calculated. If that item is incorrectly calculated and purchased incorrectly, it will bring a lot of trouble to the later use. Therefore, when purchasing an LED display, each item needs to be calculated in detail. Today, the Shandong LED display will talk about the calculation method of the scanning method.
Scanning mode: in a certain display area, the ratio of the number of lines lit at the same time to the number of lines in the entire area.
Indoor single and double color is generally 1/16 scan, indoor full color is generally 1/8 scan, outdoor single and double color is generally 1/4 scan, and outdoor full color is generally static scan.
At present, the driving methods of LED display screens on the market include static scanning and dynamic scanning. Static scanning is divided into static real pixels and static virtual, and dynamic scanning is also divided into dynamic real image and dynamic virtual. The driving device generally uses domestic HC595, Taiwan MBI5026 , Japan Toshiba TB62726, generally have 1/2 sweep, 1/4 sweep, 1/8 sweep, 1/16 sweep.
List the description:
A commonly used full-color module pixel is 16*8 (2R1G1B), if it is driven by MBI5026, the total module used is: 16*8*(2+1+1)=512, MBI5026 is a 16-bit chip, 512/ 16=32
(1) If 32 MBI5026 chips are used, it is a static virtual
(2) If 16 MBI5026 chips are used, it is a dynamic 1/2 scan virtual
(3) If 8 MBI5026 chips are used, it is a dynamic 1/4 scan virtual
If the two red lights on the board are connected in series
(4) Using 24 MBI5026 chips, it is a static real pixel
(5) Using 12 MBI5026 chips, it is a dynamic 1/2 scan real pixel
(6) Using 6 MBI5026 chips, it is a dynamic 1/4 scan real pixel
On the LED unit board, the scanning modes are 1/16, 1/8, 1/4, 1/2, and static. What if there is a distinction?
One of the easiest ways is to count the number of LEDs on the unit board and the number of 74HC595s.
Calculation method: the number of LEDs divided by the number of 74HC595 divided by 8 = fractional scan
Real pixels correspond to virtual ones: in simple terms,
The real pixel screen means that each of the three light-emitting tubes of red, green and blue that constitute the display screen ultimately only participates in the imaging use of one pixel to obtain sufficient brightness.
The virtual pixel uses a software algorithm to control the light-emitting tube of each color to eventually participate in the imaging of multiple adjacent pixels, so that a larger resolution can be achieved with fewer lamps, and the display resolution can be increased by four times.

