When electronic products always fail, we will analyze how to overhaul industrial displays today:
1. Observation method: As the name implies, it is to visually check whether the components are burnt, damaged, deformed, discolored, broken, and the filament of the picture tube is not bright after the current is connected. These problems are often the fault or are closely related to the fault. Find these The problem can be quickly identified and the industrial display can be repaired.
2. Percussion method: This is also one of the very effective methods for repairing the display, especially for faults caused by poor contact. The method is to use the insulator to lightly tap and press the parts that may have problems with or without power, so that faults such as false welding and poor contact can be found more easily.
3. Replacement method: Replacement method is a practical and quick maintenance method. When you are not sure about which component, you can replace it first, and replace it with a good component. If the fault is eliminated, it proves that the original component is faulty. This is especially true for some components that are inconvenient to measure.
4. Current measurement method: Measuring current is one of the basic methods for repairing industrial displays. It is mainly used to measure the load current and working current of transistors and integrated circuit blocks, in order to detect whether the integrated circuits, transistors and their power loads are normal, and so on. As long as the measured load current of the transistor or integrated circuit is normal, it can be concluded that the working state of the circuit is basically normal. Conversely, if the current changes greatly compared with the normal value, it means that there is a problem with the circuit, and you can prescribe the right medicine and conduct key inspections.
5. Voltage measurement method: Measuring voltage is also one of the basic methods of repairing the display, which is often used in practice. It is mainly to measure the working voltage of circuits and components to determine the fault location and components. Voltage measurement can be divided into two categories: AC voltage measurement and DC voltage measurement. To measure the AC voltage is to use the AC voltage block of a multimeter to measure the AC voltage value of the display power supply. Of course, you can also connect a capacitor with a voltage resistance of about 0.1 μF to the multimeter in series to measure the AC part of the field scan output circuit, line scan output circuit, and video amplifier circuit. Check the AC voltage with a multimeter, and then compare it with the measured value under normal conditions to judge whether the circuit is working normally.

