Many times we cannot install the LED display immediately after purchasing it due to some factors. In this case, we need to store the LED display well. As a precision electronic product, the LED display has high requirements on storage methods and environment. Accidentally, it may be the result of damage to the LED display. Today we will talk about how to store the LED display correctly.
There are eight points to pay attention to when storing LED displays:
(1) After cleaning the place where the box body is to be placed, it should be laid with pearl cotton.
(2) It is strictly forbidden to stack modules in disorder or stack more than 10 sheets of LED display. When the modules are stacked, the lamp surfaces are placed relative to each other and separated by pearl cotton.
(3) The placement of the LED display box is recommended to be placed flat with the lamp facing up. If there are too many, you must pay special attention to protection when it is placed upright. It is forbidden to place it upright in places with large vibrations.
(4) The display box body should be handled with care. When landing, the back side first touch the ground and then the lamp surface, beware of knocks.
(5) All staff must wear a cordless anti-static wristband when installing or repairing.
(6) Use an anti-static wristband for LED display installation
(7) The box should be lifted when transporting it, and it should not be pushed or towed away on the ground, so as to avoid the unevenness of the ground causing damage to the bottom module. The box body should be balanced during the lifting process, and should not swing or rotate left and right in the air. When installing the cabinet or module, handle it gently, and don't throw it.
(8) If the LED display product needs to be adjusted, use a soft rubber hammer to hit the metal part of the box, and it is strictly forbidden to hit the module. It is strictly forbidden to squeeze or collide between modules. In the case of gaps, abnormal positioning, etc., it is strictly forbidden to use a hammer or other hard objects to hit the box and module. You can pick up the box and try again after removing the foreign objects.
