The LCD splicing screen can be installed in many ways. Depending on the application, different installation methods can be used. Currently, the most common installation methods are as follows:
1. Floor cabinet installation
The floor-to-ceiling cabinet is installed with all-steel, computer gray appearance, plus electrostatic protection, the entire system has a beautiful and atmospheric appearance, and the system is relatively simple to run.
2. Wall-mounted installation
Wall-mounted bracket installation is to first fix the bracket on the wall with expansion bolts, and then hang the splicing screen. The debugging is good, and the installation is simple and quick. However, if the number of splicing screens is relatively large, it may not be possible to carry the wall.
3. Embedded installation
Flush mounts are used to dig out the space on the wall and then trim the screen. The advantage is that it can be better integrated with the surrounding environment, thereby saving more space.
4. Vertical bracket installation
In the vertical bracket installation method, the entire splicing screen system is supported by the bracket, and the bracket supports the weight of the entire system. This installation method requires that the floor to be installed is flat, the floor is strong enough, and the requirements for splicing brackets are high, and the installation is conducive to system maintenance and fault repair.
There are two common maintenance methods for LCD splicing screens:
1. Maintenance mode before external drag and drop
Pre-maintenance usually closes the screen in front of the large screen and then performs maintenance; there are two types of electric and manual; the large screen installation of this maintenance method is very complicated, and only two large screens can be spliced (it is recommended that most of them are at the same time, because it is necessary Leave an edge to remove the large screen from the front, and the gap between the large screen will inevitably become larger, which will affect the display effect to a certain extent.
55 inch 1.8mm
2. The post-maintenance mode of the maintenance access channel remains behind.
Rear maintenance refers to the maintenance of the back of the large screen. Sufficient maintenance access rights must be reserved on the back of the screen. Generally, it needs to be about 70 cm to 1 meter wide. The requirements for architectural space are very high, and to a certain extent. Compress the visible space. Most projects now use post-maintenance methods
