1. Check the wiring port
First check whether the wiring interfaces are loose, and then check whether there is a conflict between the serial port and the interrupt number. If there is a conflict, adjust the resources to avoid the conflict. Then check whether there are cracks on the surface of the industrial touch screen. If there are cracks, replace them in time. It is also necessary to check whether there is dirt on the surface of the touch screen. If there is, use a soft cloth to remove it. Observe and check whether the indicator light on the control box is working properly. When it is normal, the indicator light is green and flashing.
2. Comprehensive inspection of replacement method
If the above parts are normal, you can use the replacement method to check the industrial touch screen, first replace the control box, then replace the touch screen, and finally replace the host.
(1) It may be that one of the wires of the touch screen is not connected to the keyboard port of the host (take the 5V touch screen operating voltage from the keyboard port). Please check the connection.
(2) It may be that the serial port number selected during the driver installation process of the touch screen does not correspond to the serial port number actually connected to the touch screen. Please uninstall the driver and install it again.
(3) It may be that the host is a domestic original machine, and the installed operating system is an OEM version, which has been adjusted by the manufacturer, resulting in non-standard serial communication and incompatibility with the touch screen driver. If feasible, please format the hard disk and install the system to drive it. touch screen.
(4) It is possible that the version of the touch screen driver is too low, please install the latest driver.
(5) Whether there is a conflict between the device and the serial port resource in the host. Check the hardware devices and adjust them. For example, the default IRQ of some network cards after installation is 3, which conflicts with the IRQ of COM2. At this time, the IRQ of the network card should be changed to idle and unused IRQ.

