1. install gasket: the module is best installed with the front panel about a 0.1MM liner, Panel should be absolutely smooth, guaranteed after Assembly without distortion and improving seismic performance.
2.Protective film: module installed in the finished product has a protective film on the surface of LCD output device, in case of assembling the stained surface, in assemblies shall not be removed until the end, so as not to stain or tarnish the output surface.
3. to prevent static electricity: module is the control and driving circuit low voltage, low power consumption CMOS circuits, vulnerable to electrostatic breakdown, and sometimes as much as several ten volts or hundreds of volts of high voltage static electricity, so operation, Assembly and carefully to prevent static electricity.
